|
|
||
|
|||
 |
|
||
 |
|
||
 |
|
||
 |
|
||
 |
|
||
 |
|
||
 |
|
||
 |
|
||
 |
|
||
 |
|
||
 |
|
||
 |
|
||
 |
|
||
|
|||
| Stecktronics LED Lights | |
 |
||||||||||||||||||||||||||
Stecktronics Navigation/Foredeck LightNote: This is a retrofit all-around light and is not USCG certified. This LED Navigation Light System is unique in many ways. Incredibly low current draw, an unheard of 160 ma.* (.16 amps)!! This is approximately 10th the current draw compared to its original factory bulbs! (Plus or minus 10%). Every sailor knows that while under sail at night and your main engine or generator is not running, your navigation lights will slowly but surely drain your house bank batteries to an unacceptable low level. With Stecktronics LED technology, this is no longer a problem. With three LED navigation light fixtures burning bright, you will use only 5.0 amps total, for an entire night of sailing. Compare this to 50 amps or more with incandescent lighting, and you will realize the advantages of Stecktronics LED navigation lighting. You might ask, why should I change to LED lighting for my masthead light (steaming light) because my charging source is already running? LED lights have a life expectancy of up to 100,000 hours. This equates to approximately 22 years of night time use before climbing the mast to replace the LED. This is reason enough to switch to LED technology. Installing Stecktronics LED modules into existing fixtures is fairly simple. You may download an instruction manual to read about the process.
Stecktronics Spreader LightA LED spreader light that will cut your current draw by 90%. With a slight reduction in luminescence, you can use your spreader lights without the fear of dead batteries. Since LED lights are known to be directional, they absolutely SHINE in this application. Check out the features:
Retrofiting your existing spreader light to Stecktronics LED technology is almost as easy as a bulb change. Remove the old bulb by removing the split retainer ring, then clip off the connection terminals that were connected to your old bulb and reattach to the wires of the LED wafer. Twist the two red wafer wires together and connect to your positive supply wire. Insert wafer into housing and reinstall retainer ring.
STM-780 Ultra-Efficient LED Light System All-Round Anchor LightIncredibly low current draw, an unheard of 80 ma.* (.08 amps)!! Compare this to other LED lights of equal brightness that draw 260 ma (.26 amps). This is an almost 70% drop in current draw!! *Plus or minus 10% It's modular design allows you to retrofit your existing all-round light into an ultra high- efficiency LED light, at a very low cost. Or purchase a fully assembled AquaSignal? light. You have the option to make your light fully automatic, on at dusk and off at dawn, whether you build your own or purchase one already assembled.
|
|
Copyright © Hotwire Enterprises -- John Gambill & Libbie Ellis
102 West Fulton Street (map)
Tarpon Springs, FL 34689
Phone/Fax: 727-943-0424
Cell 727- 638-7417
hotwiregam@aol.com